Impinj R705 Portal Gateway Reader Installation and Operations Guide
Version 0.1
9
Warning: The RF settings must match the
country/region of operation to comply with local
laws and regulations. You, the user, are
responsible to ensure operation with the correct
RF settings and are solely responsible for any
fines and other damages due to incorrect or non-
compliant country/region settings on your
Gateway.
Avertissement: Les paramètres RF doivent
correspondre au pays / region d’exploitation se
conformer aux lois et règlements locaux. Vous,
l’utilisateur, sont chargés d’assurer le
fonctionnement avec les paramètres RF correctes
et sont seuls responsables de toutes les amendes
et autres dommages imputables à des
manipulations ou les paramètres de pays /région
non-conformes sur votre lecteur.
2.3.1
To set the region for a gateway
by using a web interface
1. Connect to the gateway by using a web browser using the following format:
http://<gateway name or IP address>.
Examples:
• http://impinj-10-00-DD
• http://10.0.10.44.
2. Log in to the gateway using the administrator credentials. The default credentials are as
follows:
user name: root
password: impinj
Note: ‘impinj’ is the default password. It is recommended you create your own after
logging on for the first time.
3. Select one of the available regions from the dropdown list.
Note: If you do not see your country or region listed, contact Impinj to find out about
current regulatory approval status.
4. On the Change Regulatory Region dialog, click Reboot. When you change the operating
region, the change does not take effect until the next reboot. If you attempt RFID operations on
the gateway after you change the region but before you reboot the gateway, you will get
unexpected behavior.
2.3.2
To set the region using RShell commands
Alternately, you can use the following RShell commands to set or change an operating region:
o
show system region
