STEP 2 (See Diagram 2)
A.) Slide the two Safety Catches (#12) onto the two Front Vertical Beams (#9) and the Guide
Rods (#16). Push them down to the selected hole on the Front Vertical Beams and insert a
Lock Knob (#15) to obtain the desired height for each Catch.
B.) Slide two Rubber Bumpers (#14) onto each of the Guide Rods (#16). Then slide two Sliding
Blocks (#17) onto each of the Guide Rods.
C.) Note: Help of another person is strongly recommended for this step. Insert the 7’ Long Bar
(#56) through the Sliding Block (#17) from one side. Position the 4’ Chrome Bar Sleeve
(#53) in between the two Sliding Blocks (#17). Continue inserting the 7’ Bar through the 4’
Chrome Bar Sleeve and the Sliding Block (#17) on the other side.
D.) Slide two
∅
3” Rubber Bumpers (#54) onto the Bar from both sides. Then plug two Plastic
Olympic Sleeves (#57) onto the bar from both sides. Securely tighten the M8 x 5/8” Allen
Bolt (#55) on the Sliding Block (#17).
E.) Attach the Front Top Beam (#19) onto top of the Front Vertical Beams (#9) and Guide Rods
(#16). Secure them with two M10 x 3 ½ Carriage Bolts (#68),
∅
¾” Washers (#5), and M10
Aircraft Nuts (#6) on each end. Make sure the top of the Guide Rods (#16) are inserted into
the holes on the Front Top Beam (#19). Secure them with two M8 x 3/8” Allen Set Screws
(#60) on the Front Top Beam (#19).
5