NOTE: It is strongly recommended that two or more people assemble this machine
to avoid possible injury.
STEP 1 (See Diagram 1)
A.)
Note: Do not tighten the Nuts and Bolts until instructed to do so.
B.) Attach the Left Rear Support (#5) onto a Base Frame (#3). Secure it with two M10 x 3
½” Allen Bolts (#32), four Ø ¾” Washers (#37), and two M10 Aircraft Nuts (#38).
Repeat the same step to install the Right Rear Support (#6) onto the other Base
Frame.
C.) Connect the Left and Right Rear Support by the Cross Brace (#7). Secure each end of
the Cross Brace to each Rear Support with four M10 x 2 3/8” Carriage Bolts (#27), one
5 7/8” x 3 1/8” Bracket (#16), four Ø ¾” Washers (#37), and four M10 Aircraft Nuts
(#38).
DIAGRAM 1
6
STEP 2 (See Diagram 2)
A.)
Do not tighten Nuts and Bolts until instructed to do so.