STEP 4 (See Diagram 4)
A.) Attach the Leg Developer (#6) to the open bracket on the Front Support (#10).
Secure it with one M10 x 3” Allen Bolt (#30), two
∅
¾” Washers (#33), and one M10
Aircraft Nut (#38).
B.) Insert the two Foam Tubes (#8) halfway through the holes on the Leg Developer.
Push four Foam Rolls (#20) onto the Foam Tubes.
C.) Attach the Bar Holder (#12) to the Leg Developer (#6). Secure it with a L-shaped
Pin (#15). Remove the Bracket when using the Leg Developer.
D.) Attach the Arm Curl Pad (#19) to the Arm Curl Stand (#11) then secure it with two
M8 x 5/8” Allen Bolts (#32) and two
∅
5/8” Washers (#34).
E.) Insert the Arm Curl Stand (#11) into the top opening on the Front Support (#10) and
secure with a Lock Knob (#41). Use the Lock Knob to select the Arm Curl height.
F.) Attach a Spring Clip (#42) to the weight post on the Leg Developer. Attach two
Spring Clips (#42) to the Curl Bar (#14).
DIAGRAM 4
7
