Imperial Kitchen Ventilation 1930ENV Installation Instructions & Warranty Information Download Page 2

Imperial Cal Products, Inc. 

 
 
 

 

Read Before Starting Installation! Inspect your range hood prior to installing! 

 Any cosmetic defects must be reported to us prior to installation. 

Once this hood is installed, ICP will NOT accept any responsibility 

 for any cosmetic blemishes, scratches or dents in the Canopy. 

Save all original packaging if you wish to return for any reason! 

 

FIRST: 

Check your local building and electrical codes.   
 

WARNING: 

 

To reduce the risk of fire or electrical shock, Do Not use any two speed motor units with a Solid 
State control devise. 
 

CAUTION:  

To reduce the risk of fire or personal injury and to properly exhaust air, be sure to duct air  to the 
outside.  DO NOT vent exhaust air into spaces within wall, attics, ceilings, crawl spaces or       
garages. For general ventilation use only.  Do not use to Exhaust Hazardous or Explosive       
Materials and Vapors.  When venting to the outside make duct run as short and straight as      
possible.  

Avoid using elbows if at all possible as this will reduce your performance.  

Every 

elbow will decrease the performance and we will not guarantee the effectiveness of the range 
hood. 
 

No Performance Warranty when used above BBQ Style Grills.      

 

 
DO NOT use duct pipe smaller than the outlet duct opening on the hood, this will reduce  
performance and void the warranty.  DO NOT use flex ducting.  Also, use either a Roof Cap or 
Wall Cap to end run.  Be sure that all joints are taped securely in place. It is essential to have the 
proper distance between the bottom of the range hood and the cooking surface below. In most 
cases the cooking appliance manufacturers specifications will establish the fire safe minimum 
distance required, although there are other factors to consider: 



Local Building Codes 



Cross directional air movements ie: open windows,  air conditioning/heating outlets, cooling 
fans, etc. 



Overall size of the cooking appliance and surrounding countertop surfaces. 



Range hood model selected. 

 
For best performance distance between cooking surface and the bottom of the hood is 30” and 
36”.  Check local codes and appliance specifications. Keep in mind, increasing the distance will 
decrease the performance.  

 

DISCLAIMER 

Imperial assumes no liability regarding the improper installation or misapplication of its products.  It 
is the installer’s responsibility to check for proper installation.  Under no circumstances will Imperial 
be liable for any labor charged or travel time incurred installation of its products.  Damage caused 
by improper installation is the installers responsibility and Imperial assumes no liability. 

 

WARNING:  This product can expose you to certain chemicals, which are known to the State of California to cause 
cancer or birth defects or other reproductive harm.  For more information to go:  www.P65WARNINGS.ca.gov. 

Summary of Contents for 1930ENV















Reviews: