MH630 240V / MH631 110V Vibrating Hammer
MH630
5.
Be sure the bit is secured in place before operation.
6.
Under normal operation, the tool is designed to produce vibration. The screws can come loose
easily, causing a breakdown or accident. Check tightness of screws carefully before operation.
7.
In cold weather or when the tool has not been used for a long time, let the tool warm up for a
while by operating it under no load.
This will loosen up the lubrication. Without proper
warm-up,
hammering operation is difficult.
8.
Always be sure you have a firm footing.
Be sure no one is below when using the tool in high
locations.
9.
Hold the tool firmly with both hands.
10.
Keep hands away from moving parts.
11.
Do not leave the tool running.
Operate the tool only when hand-held.
12.
Do not point the tool at any one in the area when operating.
The bit could fly out and injure
someone seriously.
13.
Do not touch the bit or parts close to the bit immediately after operation; they may be
extremely hot and could burn your skin.
14.
Do not operate the tool at no-load unnecessarily.
15.
Some material contains chemicals which may be toxic. Take caution to prevent dust inhalation
and skin contact.
Follow material supplier safety data.
SAVE THESE INSTRUCTIONS.
WARNING:
DO NOT let comfort or familiarity with product (gained from repeated use) replace strict adherence
to safety rules for the subject product.
MISUSE or failure to follow the safety rules stated in this instruction manual may cause serious
personal injury.
FUNCTIONAL DESCRIPTION
CAUTION:
•
Always be sure that the tool is switched off and unplugged before adjusting or checking function
on the tool.
Switch action
1. Switch lever
CAUTION:
•
Before plugging in the tool, always check to see that the tool is switched off.
•
Switch can be locked in "ON" position for ease of operator comfort during extended use. Apply
caution when locking tool in "ON" position and maintain firm grasp on tool.
•
To start the tool, push the switch lever "ON (I)" on the left side of the tool. To stop the tool, push
the switch lever "OFF (O)" on the right side of the tool.
OFF
ON
1