ImmersionRC | EzUHF R/C Control System
12
EzUHF Receiver, 8 channel version, Connections
Servo connectors on the 8 channel receiver have the pin-out shown below.
Note that the binding button is not hidden under the padded label, it is located between the
two stacked PCBs, and needs to be pressed using a non-conductive stylus, or similar.
Powering the Rx when using high-powered servos
It is very important to take care with powering the Rx, especially when high torque digital servos are
used.
If a BEC is used, ensure that it can deliver the current required by the servos. Digital servos can create
huge current pulses on the power line, and if the impedance of the supply is too high, these will cause
the receiver to malfunction.
The use of a high-performance BEC, such as the Turnigy 5-7.5A UBEC (HobbyKing) is recommended
instead of the BEC built into the ESC.
Alternatively, for installations on larger planes, with many servos, a PowerBox should be considered.
Gnd
+5/6v
Signal
