1.2 Safety Instructions
1. INTRODUCTION
■
1 x TWIST-
6
0LED
■
1 x Power cord
■
1 x Mounting bracket
■
1 x User Manual
!
Warning!!! To reduce the risk of fire, electric shock, or injury to persons,
follow these important safety instructions:
Caution!
Av
o
id looking directly into the LED light beam at a close distance!
1
Thank you for selecting this product. Equipped with
a
6
0W white LED
engine
, this LED Moving Head is
compact, light weight but powerful
. It offers
DMX, Auto, Sound, Master/Slave. Ideal for small clubs, bars, parties, etc. To
optimize the performance of this product, please read the user manual carefully
before use.
1.1
Unpacking
The following items are included in the box:
1.3 Features
▪
LED Spot moving head
▪
4-button OLED display
▪
1 color wheel: 7 white, rainbow
▪
1 Gobo wheel: 5 gobos + open, shaking
▪
3-facet prism
▪
Motorized focus
▪
4 working modes: DMX, Auto, Sound, Master/Slave
▪
DMX modes: 1
5
/
10
channels
▪
Pan : 540° Tilt: 270°
▪
The product is for indoor use only.
▪
Always turn off, unplug power and allow fixture to cool before servicing.
▪
Ensure that fixture is properly grounded.
▪
Please keep this User Guide for future consultation.
▪
Always make sure that you are connecting to the proper voltage and that the line
voltage you are connecting to is not higher than that stated on decal or rear
panel
of the fixture.
▪
Always disconnect from power before servicing or replacing fuse.
▪
Make sure power cord is never crimped or damaged.
0-100% linear dimmer
1-25 fps strobe
Carefully unpack the carton, check the
contents to ensure that all parts are
present, and have been received in good
condition.
Contact your supplier
immediately and retain packing material
for inspection if any part is missing or
damaged.
▪
▪
1.4 Product overview
2. SETUP
2
2.1 Mounting
The Moving Head is fully operational in any mounting position, hanging upside-
down, side mounted, or set on a flat llevel surface, etc.
IMPORTANT!!! Safety cables must always
be used when unit is celling or truss
mounted. The safety cable must be
capable of holding 10 times the weight of
the fixture.
2.3 AC Power
The fixture is designed to work on
AC 230V 50Hz. All units must be powered
directly from a switched circuit.
This unit cannot be run on a rheostat or
dimmer circuit even if used solely for a
0% to 100% switching.
WARNING!!! All fixtures must be connected to circuits with a
suitable Earth Ground.
Control Panel
DMX In/Out
