Machine Connection
Cables must have a male XLR connector on one end and a female XLR connector on the
other end.
A word on termination: DMX is a resilient communication protocol,
however errors still occasionally occur. Termination reduces signal errors, and therefore best
practices include use of a terninator in all circumstances. If you are experiencing problems
with erratic fixture behavior, especially over long signal cable runs, a terminator may help
improve performance.
To build your own DMX Terminator: Obtain a 120-ohm, 1/4-watt
resistor, and wire it between pins 2&3 of the last fixture. They are also readily available from
specialty retailers.
Complimentary signal cable can transmits signals to 20 unit
fixtures at most. Signal amplifier is a must to connect more fixtures
and must weld a 120-ohm, 1/4-watt resistor, and wire it between
pins 2&3 of the last fixture
5
6
Controlling Board
The display is blackout automatically if there is no any operation within 30 seconds;
Press Enter and hold for 5 seconds to show light current operating temperature;
Press MENU and hold for 5 seconds to lock KEY; Press MENU and hold for 5 seconds to
unlock KEY.
Button
Menu
Switch menu level / to return the higher
menu level
UP
Scroll upwards
DOWN
Scroll downwards
ENTER
Confirm and save a setting
