background image

 

Battery 
installation

 

1.  Loosen the screws on the battery cover. 

2. 

Open the battery cover and put batteries into the battery 
case according to the polarity shown in the battery slot. 
Replace the battery cover and tighten the screw.

 

 

 

Initial Set up

 

In order to ensure the measurement accuracy, it is recommended 
that you check the accuracy before operating. 

 

After fitting the batteries, place on a flat horizontal surface with the 
LCD display facing you and press the power button to turn the 
EL30 on.  Record the angle value (A) on the display. 

 

Rotate the EL30 180° with the screen facing away from you and 
record the value (B). 

 

If A, B angle value margin exceed 0.2 degree, it is necessary to 
calibrate the horizontal accuracy. 

 

Also follow above procedure in vertical position to check vertical 
accuracy

 

 

 

Calibration

 

1.  Select a flat and horizontal platform as a reference 

surface 

2.  Press the power button to turn the unit on  
3.  Press and hold the ZERO button until -0- is displayed on 

the LCD screen. Wait 3 seconds, press the ZERO button 
again the LCD will now display -1- 

4.  Turn the unit 180 degrees, keeping the unit on the same 

horizontal platform, and wait for 3 second, then press 
ZERO, the LCD will display -2-, and then will display angle 
value. Horizontal calibration is now complete. 

 

Note: all the above operation should be operated on the same 
position of the same plane.  

 

To calibrate vertical plane, repeat above procedure on vertical 
plane.

 

 

 

Technical 
Specifications

 

 

 

Measuring Accuracy 

±0.1° 

Working Range 

0°- 360° 

Display Mode 

5 x Display modes 

Resolution 

0.1° 

Laser wavelength 

650nm / Class 2 

Laser indication range 

±0.3mm/m 

Power 

3 x AAA Batteries 

Working temperature 

-10°C to +45°C 

Size 

305 x 60x 32mm 

Weight 

670g with batteries 

Summary of Contents for EL30

Page 1: ... and serial number of your product are indicated on the product Please keep a these recorded in your manual and always refer to this information should you need to contact your Imex distributor Model number Serial number Validity of this manual This manual applies to the Imex EL30 Digital Level and contains instructions required to operate at a basic level For more information www imextools co uk ...

Page 2: ...the product and the application becomes unsafe To ensure that the national laws regulations and conditions for the operation of Operation Instrument Overview Functions Power Mode Select Calibrate Sound Backlight Hold Laser on off Press to turn the EL30 on off Select to display mm m inch ft Long Press to enter calibrate mode Short press to turn sound on off Long press to turn backlight on off Press...

Page 3: ...al position to check vertical accuracy Calibration 1 Select a flat and horizontal platform as a reference surface 2 Press the power button to turn the unit on 3 Press and hold the ZERO button until 0 is displayed on the LCD screen Wait 3 seconds press the ZERO button again the LCD will now display 1 4 Turn the unit 180 degrees keeping the unit on the same horizontal platform and wait for 3 second ...

Page 4: ... the instrument Keep the instrument clean Keep away from of wet and damp conditions Do not attempt to disassemble the unit as any unprofessional disassembly will result in damage to the instrument Take the batteries out when the instrument is not in use for long periods of time Version 05 English Copyright Imex Group International UK LTD 2016 ...

Reviews: