9
Operation
1. SWITCHING ON AND OFF
Button switches on the Bullseye 30 and laser. The display shows the battery symbol
until the next button
is pressed.
Press and hold the
button to switch OFF the Bullseye 30.
The Bullseye 30 switches off automatically after three minutes of inactivity.
2. CLEAR BUTTON
The last action is cancelled. While making area or volume measurements, each
single measurement can be deleted and remeasured in series.
3. REFERENCE SETTING
The default reference setting is from the rear of the Bullseye 30. The display will show
Press the
button to change the reference to the front. The display will show
Press the
button, to set the rear reference again.
Release belt clip and replace in opposite direction to extend the device.
Press the
button to measure with the bracket as the reference edge. The display
will show
Measuring
1. SINGLE DISTANCE MEASUREMENT
Press
to activate the laser. Press
again to trigger the distance measurement.
The result is displayed immediately.
2. CONTINUOUS MEASUREMENT
Press and hold down this button for 2 seconds to make a continuous measurement.
Press it again to stop the continuous measurement.
