EN
83
PROBLEMS AND SOLUTIONS
The appliance
does not
go on
1. Make sure that the connector (7b) is inserted correctly into the
base connection (6).
2. Make sure that the power supply plug (7a) is inserted into a wall
socket.
No light is
emitted when
the pulse
activation
button (19)
is pressed
1. Make sure the surface treatment (17) is evenly and firmly
pressed on the skin. OR
2. Check the skin colour check LED (15): if it flashes for 3 seconds,
the skin tone is too dark for a safe application. Try to use the
appliance on another part of the body or contact the IMETEC
service centre. OR
3. Check the lamp replacement LED (14): If it stays on, contact the
IMETEC Customer Service Centre. OR
4. Verify that the ready-for-use LED (11) is on.
If the ready-for-use LED (11) remains off after 10 seconds, switch
the appliance off and on again by pressing the switch-on/stand-by
button (8) twice.
If the problem persists, contact the IMETEC Customer Service
Centre. OR
5. Check the error/fault LED (16): if the LED is on, switch the
appliance off and on again by pressing the switch-on/stand-
by button (8) twice. If the problem persists, contact the IMETEC
Customer Service Centre.
Summary of Contents for I6601
Page 3: ...DATI TECNICI DATOS T CNICOS TECHNICAL DATA DADOS T CNICOS TYPE I6601 100 240V 50 60 Hz 2A II...
Page 117: ......
Page 118: ......
