EN
13
USE
Filling the removable water reservoir
The water reservoir can be removed and filled at any time during use.
Fill the water reservoir (1) before using the appliance and when the no water LED (8) lights
up.
1. Remove the water reservoir (1) from the steam generator (Fig. C).
2. Fill the reservoir with tap water up to the maximum level (Fig. D).
3. Reinsert the reservoir in the steam generator sliding it along the guides until it clicks
into position (Fig. E).
ATTENTION! Do not overturn or shake the steam generator when the
reservoir is full.
Intellivapor technology
This boiler is equipped with "IntelliVapor" technology, which allows you to iron any type of
fabric without having to adjust steam and plate temperature.
Fabrics with the following symbols can be ironed (linen, cotton, silk, polyester wool, and
viscose)
Fabrics with this symbol cannot be ironed (spandex, elatsan or prints)
Ironing
•
Place the boiler on a flat and firm surface.
•
Ensure that there is water in the reservoir (1) (see chapter: "Filling the removable water
reservoir").
•
Connect the plug (4) to a suitable socket.
•
Press the ON/OFF button (3).
•
Upon switch-on, all the LEDs on the dashboard will light up simultaneously for a few
seconds.
•
Start ironing when the steam (ready) LED (6) lights up and stops blinking. The plate
temperature LED (11) goes on and off intermittently while ironing, indicating that the
appliance maintains the optimal temperature.
•
Press the steam button (13) to steam iron.
•
Dry iron by not pressing the steam button (13).
Steam shot
The steam shot function can be used to eliminate difficult creases.
•
Press the steam button (13) three quick consecutive times to activate the "steam shot"
function. In this mode, the system delivers steam continuously.
•
Press the steam button again (13) to deactivate the "steam shot" function.
