10
EN
the filters are probably very dirty. In this case, replace them. To do so, follow the indications provided
by the symbol in the figures. clean the dust collection system following the instructions below and
paying attention to the figures in the illustrative guide.
Cleaning the dust container (10A)
• press key (9) on the handle and take the container (10a) out of the appliance [Fig. d1].
• Open the lid of the container (10B) using the release button (10c) and empty out the
container (10a) [Fig. d2, d3].
• When necessary, rinse the container (10a) and dry it completely.
• The cyclone filter (10e) and the protective grille (10d) can also be rinsed if they are
very dirty. To do so, proceed as follows:
• carefully release the fastening flap (10G) on the cyclone filter cover (10F) and take
the cyclone filter out (10e) [Fig. d4, d5].
• release the protective filter for the grille (10d), as illustrated in the figure [d6], and
take it out.
• clean the parts with running water and then leave them to dry completely.
• let the filter dry for at least 24 hours after washing it.
• assemble the appliance, proceeding in reverse order. refer to the figures [d7, d8].
• Before turning the appliance on, put the container (10a) back inside.
Note: the outlet filter (7) must be changed once a year (based on use).
Replacing the outlet air filter (7)
• press the interlock on the air outlet grille (6) and take it out [Fig. d9].
• Take the outlet air filter out (7) and replace it with a new filtering insert [Fig. d10].
• refit the air outlet grille (6) and snap the interlock in place.
DISPOSAL
The product is packaged in recyclable materials. dispose of it in compliance with the
environmental protection standards.
The appliance must be disposed of in compliance with eu standard 2002/96/ec.
The recyclable materials contained in the appliance must be collected to prevent
environmental pollution. For further information contact the local waste authority or
the appliance retailer.
ASSISTANCE AND WARRANTY
To request repairs or purchase spare parts please contact IMeTec’s authorised customer
service centre on the Toll-Free Number below or via the website.
The appliance is covered by the manufacturer warranty. For details, read the attached
warranty sheet.
Failure to comply with the instructions for use and maintenance provided in this manual will
render the manufacturer’s warranty null and void.
www. imetec.com
Tenacta Group S.p.A. Via Piemonte 5/11 24052 Azzano S. Paolo (BG) ITALY
Tel. +39.035.688.111 Fax +39.035.320.149
MI001404
0214 (MMYY)
