IMET B034, Technical Manual, Page: 13 / 25

TECHNICAL MANUAL
Page n°13 of 25
RF TRANSCEIVER MODULE 2.4GHz
B034
Doc. Revision°:0
Date: 11/01/2021
Technical Manual file.dot revisione n° 0 data: 24/02/2020
IMET s.r.l.
Via Ronche, 93 33077 Sacile (PN) – ITALY – Tel. (+39) 04347878 – Fax (+39) 0434 737848 P.IVA C.F. e Reg. Impr. PN:01106390931 R.E.A.
43483 CCIAA PN http//www.imet.eu e-mail: info@imet.eu
4.1 PIN Description table
PIN Symbol Type Description
J65 PWDN LDO Power enable; Power ON / Power OFF the RF module
J94 GND Ground Ground
J92 GND Ground Ground
J93 GND Ground Ground
J80 GND Ground Ground
J63 VREG Power Power supply input
J12 GND Ground Ground
J62 LED1 GPIO General porpouse digital input /output use only for debug
J100 LED2 GPIO General porpouse digital input /output use only for debug
J101 LED3 GPIO General porpouse digital input /output use only for debug
J5 DATA -RX DI UART Serial communication data input
J68 GND Ground Ground
J8 DATA-TX DO UART Serial communication data output
J74 CFA-REQ DI Digital input for frequency change request
J67 TM_EN GPIO Reserved for internal used
J64 GND Ground Ground
J69 JT JTAG JTAG signal
J70 RESET Reset Microcontroller Reset PIN
J71 JTCK JTAG JTAG signal
J102 JTDI JTAG JTAG signal
J72 JTDO JTAG JTAG signal
J103 JTNRS JTAG JTAG signal
J73 3.3V 3.3V Power supply for microcontroller during programming phase
DO = Digital Output ; DI = Digital Input; GPIO = general porpouse input output
Table 3