Goblin Shark - User Manual
13
IMENCO AS
Visiting Address:
Kophaug 3, 5570 Aksdal, Norway
Office: +47 52 86 41 00 [email protected]
Org No: 923 005 749 MVA
Postal Address:
PO. Box 2143, 5504 Haugesund, Norway
Fax: +47 52 86 41 01
www.imenco.com
6
Maintenance
6.1
General maintenance
After use in seawater or other corrosive environments, rinse the unit and cables in fresh
water.
Inspect the front port for dirt and dust and remove any surface dirt using
compressed air. Clean the front port glass using a mild detergent and a soft
cloth. Do not use alcohol or solvent based cleaning solutions because that could
damage the pressure seals and glass coating. Avoid circular wiping patterns.
Reapply silicon based lubricant to the connector regularly as needed.
6.2
Service and Repair
This product contains no user serviceable parts. Service and modifications are to
be carried out by Imenco personnel or by qualified third party after
appointment. Failure to comply may result in personal injury, damage to
equipment and loss of warranty.
If the Goblin Shark camera seems to be not working properly, please try to speed
up the service that Imenco can provide by describing the problem in specific
terms from the person who have first handed observed the fault. Remember if
necessary to describe the system where the camera is installed since the root
cause sometimes can originate outside a failing part in an advanced system.
7
Packing & Shipping
The packing & shipping of the goods shall generally be according to Imenco’s approved
procedures.
Warning:
The Goblin Shark camera includes fragile parts which must not be subject to
vibrations and shock during transport.
The subsea connector should be protected with a dust cap whenever it is not connected to a
cable.
- - - - -
