6
IP700
OPERATING :
·
Turn the key switch to select the ON position.
·
Select NORMAL or CONSTANT operation.
If NORMAL is selected the unit will cycle once only: the ram will move to the down
position, pause for four seconds and return to the fully up position where it will stop.
CONSTANT leaves the ram in the down position until released by turning the switch from
constant to normal. Use this mode for resilient material which has resistance to
compaction.
·
Open the door and place waste material into the wheelie bin. Waste may also
be placed into the bin before is pushed into the machine.
·
Close the door fully and press the START button, the run indicator will light
while the ram is moving or in the down position.
·
The machine will not operate unless the truck is properly locked into position
and the door is closed.
·
To stop the machine at any point in its cycle press the STOP button.
To restart press the START button - the machine will continue its cycle.
·
Continue compacting until the bag full light comes on. Bag full levels are
dependent on the type of waste being processed. Do not overfill the bin as this
makes it difficult to withdraw.
·
Bin full levels are dependant on the type of waste being processed. When full
remove the bin at the end of the cycle, and empty the bin.
·
It is recommended that if the machine is not in use for long periods it is switched
off at the keyswitch.
OVERLOAD PROTECTION
Under extreme load circumstances the Compactor might overheat. The switchgear
contains an overload to prevent any damage to the motor. This device will
automatically reset itself when cool, and it will only be necessary to wait a few
minutes before the machine can be restarted.
Press the START button to reset and start the machine.
If any difficulty is encountered, please contact the supplier or the manufacturer.
MAINTENANCE
Keep the Compactor and the area around it clean at all times.
Remove the truck and then, by releasing the castor brakes, the unit may easily be
moved to clean the floor beneath and behind it. (NB. Switch off the electricity supply
at the isolator or unplug the unit before moving or cleaning).
It is advisable to clean the exterior stainless steel finish periodically with a stainless
steel cleaning agent or a soapy cloth.
