© 2016 imc Meßsysteme GmbH
imc CANSAS - Getting Started, Doc. Rev. 2.0 R1 - 2016-05-24
9
Important information
1.2.1.6 Before Starting
Condensation may form on the circuit boards when the device is moved from a cold environment to a
warm one. In these situations, always wait until the device warms up to room temperature and is
completely dry before turning it on.
We recommend that you allow an approx. 30 min. warm-up phase before starting a measurement.
The module has been designed for use in clean and dry environments. They are not to be operated in 1)
exceedingly dusty and/ or wet environments, 2) in environments where danger of explosion exists nor 3)
in environments containing aggressive chemical agents.
Always arrange your cables and signal leads in a safe fashion. Think prevention!
Never connect or disconnect signal leads during thunderstorms.
