INTRODUCTION
Installing the IMC Teddy Hand Sink is a straightforward procedure that can be accomplished with normal
construction materials and techniques. Installation procedures may vary due to field conditions and state
regulations. Please note that the following instructions are recommendations only. The installer is responsible
for proper setting and making sure the appropriate codes are followed. Please contact the IMC Teddy Engineering
Department (800-221-5644) prior to considering retrofit installations. Click here for a video on mounting your
equipment on a Z-Clip:
https://bit.ly/3lmZBr2
Please read the attached information carefully, as much of the information provided is reflecting proven
installation techniques used in previous installations.
Parts Included
Position z-bracket onto wall at the
appropriate height above the floor
and mark holes for drilling. (Make
sure bracket is level.) Once holes
are drilled screw bracket to wall.
(Hardware not included.)
Install included parts, in this case
the faucet.
(Model shown is WSMS Hand Sink)
• WSMS Hand Sink
• “Z clip” Mounting Bracket
• Mounting Brackets (2)
• Faucet (Sold Separately)
Step 1:
Step 2:
Z-Clip
WSMS Hand Sink
Z-Clip
Faucet
Bracket
(Welded on Sink)
Faucet
Wall
Drill