Interchangeable Art
™
System Installation Instructions
Included with System
• Frame
• Blank Panel
• Template
• 10 Anchor Screws
• 2 Latches
• 1 #6 Screw
• Safety Strap
Space Requirements:
The minimum space requirement: 26 1/16” w x 18 1/16” h
Installation takes approximately 30 minutes.
Tools Required
• Pencil
• Level
• Drill with 1” bit
• Tape measure
• Drywall plunge saw or zip saw
• Cross thread screwdriver
Step One
Before you begin, locate any electric lines, gas lines, plumbing or wiring
before cutting into the drywall. Take care to avoid cutting or damaging
these items. Shut off all electrical power and gas to the installation area.
• Measure and
fi
nd center point of the area to be installed.
• Mark center line of frame, both vertically and horizontally.
• Use your level to mark line on the wall.
Step Two
• Place the included cardboard template on your center line marks.
• Use your level to extend the line both vertically and horizontally if
needed.
• Use your pencil to draw a line around the template, marking the area
to be cut.
Step Three
• Use drywall plunge saw or zip saw to cut frame outline, taking care to
avoid cutting or damaging any electrical lines, gas lines, plumbing
or wiring.
• Remove the cut-out.
• Clear any debris from area.
Step Four
• Set frame (with latch slots on the top) into opening to check for
fi
t.
• If there is a stud located directly behind either latch hole, drill a 1”hole
in the stud to clear a space for the latch.
