Imagine Selenio X50, Installation And Operation Manual, Page: 128 / 136

Appendix C
Servicing
114
Shaft Encoder Replacement
There are two possible replacement parts for a broken shaft encoder: a simple shaft
encoder (X50SPR-SE) that must be soldered to the front circuit board, or a complete circuit
board unit (X50SPR-DISP).
To replace a complete circuit board unit because of a broken shaft encoder, see LCD or
OLED Display Replacement on page 110. To replace a broken shaft encoder separately,
follow these steps:
1 Disconnect both power cords and remove the cover as described on page 106.
1 Remove the four electrical connectors located behind the circuit board.
Figure C-13. Removing Connectors Behind Circuit Board
2 Remove the six circuit board mounting screws ( Figure C-14 ).
Figure C-14 Mounting Screws for Front Display Board
3 Gently pull the circuit board away from the face of the X50, taking care not to bend the
memory board conductors on the left side.
Gently unplug the
connectors
1
4
3 2
6
5