Separate the inner rails from the outer rails.
For both rail assemblies: pull the inner rail out of the outer rail until it is
fully extended. Press the locking tab down to release and separate the
inner rails.
Install the inner rails on the chassis.
For each side of the chassis: place the Inner rail against the side of the chassis. Align the hooks on the side
of the chassis with the holes in the inner rail. Slide the inner rail forward toward the front of the chassis
until the rail clicks into the locked position. Attach the inner rail to the chassis with screws.
Secure the rails to the rack.
Hang the hooks on the front of the outer rail onto the slots
on the front of the rack. Secure the rails to the rack with
screws.
Power On/Off
Reset
Power
Disk Drive Activity
NIC Activity
Power Failure
Overheat
Rack Mounting
Imagine Communications
http://www.imaginecommunications.com/company/contact-us.aspx
Technical Support
http://www.imaginecommunications.com/services/technical-support.aspx
Documentation
https://files.imaginecommunications.com/get
Nexio AMP® Gen-7
Installation Quick Start
Set the length of the outer rails.
Pull out the rear of the outer rail. Adjust the length until it fits within
the posts of the rack. Hang the hooks on the outer rail onto the slots
on the rear of the rack. Secure the rear of the outer rail to the rear
of the rack with screws.
Install the chassis into the rack by aligning rails
Pull the middle rail out from the front of the outer rail. Make sure
the ball-bearing shuttle is at the front locking position of the middle
rail. Align the chassis inner rails with the front of the middle rails.
Mount the chassis into the rack.
Slide the inner rails on the chassis into the middle rails on the rack
until the locking tab of the inner rail clicks into the front of the
middle rail. Press the locking tabs down on both sides of the unit,
and at the same time push the chassis all the way to the rear of the
rack.
Chassis, Cables and Connectors
Rack Rail Kit
▪ 2RU Chassis (1)
▪ Rails (2)
▪ Power Cables (2)
▪ Slides (2)
▪ Ethernet Cables (2)
▪ Mounting Brackets (2)
▪ VHDCI/RJ 16 Port Breakout Cable (1)
▪ Mounting Hardware
▪ MDR-X75HD-Coax Cables (2)
▪ HD-BNC Male to BNC Female Cables (9)
▪ RJ-12 to DB9 Master Adapters (4)
▪ RJ-12 to DB9 Tributary Connectors (4)
▪ HD-BNC Extraction Tool (1)
▪ USB Flash Drives (2)
Customer Supplied Items
▪ VGA Monitor
▪ USB Keyboard and Mouse (HDX)
Install the outer rails on the rack
For each side of the rack: press up on the
locking tab at the rear end of the middle rail.
Push the middle rail back into the outer rail.
Use the supplied adapters for racks with
round holes.
Shipping Contents
Support and Documentation
Front View Power Switch and LEDs (Shown without Bezel)
