8
7. Identify the Right Handrail (72), which has a large hole in
the left side. Feed the Upright Wire (42) into the hole in
the bottom of the Right Handrail and out of the large hole
in the side. Note: It may be helpful to use needlenose pli-
ers to pull the Upright Wire out of the hole.
Then, attach the Right Handrail (72) to the Right Upright
(90) with two Handrail Bolts (37) and two 5/16” Star
Washers (95).
Attach the Left Handrail (71) to the Left Upright (7) in the
same way. Note: There is not a wire on the left side.
Remove the colored tie from the Upright Wire (42).
Large
Hole
72
95
42
37
37
95
71
90
7
7
5. Attach two Round Base Pads (57) and an Extension Leg
Pad (61) to the Upright Base (69) and Extension Leg
(63) with four 1” Tek Screws (39) as shown.
63
61
39
39
39
57
5
6. Attach a Wheel (66) to the Upright Base (69) with a
Wheel Bolt (64) and a Nut (13) as shown.
Do not over-
tighten the Wheel Bolt;
the Wheel should turn freely.
With the help of a second person, carefully tip the tread-
mill up so the Round Base Pads (57) are on the floor.
69
13
66
64
6
57
69
