12
Using the Controls
Air Control 1: Determines the amount of air flowing
through the hydrotherapy jets labeled 1 (above). If the
control is turned counterclockwise, the amount of air
will increase; if the control is turned clockwise, the
amount of air will decrease. Air controls 2–4 function
in the same manner.
Air Controls 2, 3, and 4: Determine the amount of air
flowing through the hydrotherapy jets labeled 2, 3,
and 4 (above).
Display Invert Button: Turns the display 180°, allow-
ing it to be read from inside or outside of the spa.
Pump Button 1: Turns the spa jet labeled 3 and 4 (at
the left) on and off. If the button is pressed once, the
jet will run, providing gentle hydrotherapy. If the button
is pressed again, the jet will shut off.
Pump Button 2: Turns the spa jets labeled 1 and 2
(at the left) on and off. If the button is pressed once,
the jets will run, providing soothing hydrotherapy. If
the button is pressed again, the jets will shut off.
The spa also features an automatic mode that heats
and filters the water when the spa is left unattended.
When the power to the spa is first turned on, or if the
water temperature is below the set temperature, the
water will be heated as required. Note: To keep the
filter and heat cycles from running, the power to
the spa must be turned off.
Light Button: Turns the underwater light on and off.
Temperature Buttons: Control the temperature setting
of the water. The temperature setting can be from
80°F to 104°F. The water heats at about 6°F per hour
with the cover on. Use a medical or other accurate
thermometer to check the temperature of the water.
Note: The word “COOL” will appear in the console
display if the temperature of the water is more than
20°F cooler than the set temperature. When this hap-
pens, the heater will automatically activate to warm the
water. The word “ICE” will appear in the display if the
temperature drops below 40°F. If this happens, the
pump will automatically circulate the water and warm
the plumbing to keep the water from freezing.
Neck Jet Valve: Controls water flow to the two neck
jets (see J on page 11).
Air Control 4
On/Off Valve
Air Controls
1, 2, and 3
Light
Button
Pump
Button 1
Pump
Button 2
Display
Display
Invert Button
1
2
1
1
2
3
4
4
1
3
3
4
Temperature
Buttons
On/Off
Valve
