12
Using the Controls
Refer to the diagram above. The function of each
control is explained below:
Air Control: Determines the amount of air flowing
through the hydrotherapy jets during operation. If the
control is turned counterclockwise, the amount of air
flowing through the jets will increase. If the control is
turned clockwise, the amount of air will decrease.
Jet Button: Turns the spa jets on and off. If the but-
ton is pressed once, the spa jets will run, providing
gentle hydrotherapy. If the button is pressed again,
the jets will shut off.
The spa also features an automatic mode that heats
and filters the water when the spa is left unattended.
When the power to the spa is first turned on, or if the
buttons on the console have not been pressed for
longer than twenty minutes, the automatic mode will
be activated. The automatic mode will filter the water
for one hour every six hours. The water will be heated
as required to maintain the set tempature. Note: To
keep the filter and heat cycles from running, the
power to the spa must be turned off.
Light Button: Turns the underwater light on and off.
Temperature Buttons: Control the temperature setting
of the water. The temperature can be set between
80°F and 104°F. The water heats at about 6°F per
hour with the cover on. Use a medical or other accu-
rate thermometer to check the temperature of the
water. Note: The word “COOL” will appear in the con-
sole display if the temperature of the water is more
than 20°F cooler than the set temperature. When this
happens, the heater will automatically activate to warm
the water. The word “ICE” will appear in the display if
the temperature drops below 40°F. If this happens, the
pump will automatically circulate the water and warm
the plumbing to keep the water from freezing.
Air Control
Temperature
Buttons
Light
Button
Jet
Button