ILVE ilfm series, Instruction Manual

Page: 12 / 16

24 25
GB
Error
displayed
Problem type Possible cause Possible solution
B Single burner locked
No gas
Restore the gas and unlock the
burners
Ionization electrode dirty or not hit by the flame
Clean or reposition the
electrode and unlock the
burners
The cook top is not grounded
Check the cables and unlock
the burners
F
Parasite flame/flame detection
circuit anomaly on the single
burner
Ionization electrode wired incorrectly Check the wiring
Failure at the circuit Replace the device
Flt00
Main valve control circuit
anomaly
Failure at the circuit Replace the device
Flt01
Anomaly circuit voltage of
reference
Failure at the circuit Replace the device
Flt02 Watchdog circuit anomaly Failure at the circuit Replace the device
Flt03 Microcontroller door anomaly Failure at the circuit Replace the device
Flt04 Eeprom anomaly Failure at the circuit Replace the device
Flt05 Pilot valve circuit anomaly Failure at the circuit Replace the device
Flt06
Limit of 5 unlocks in 15
minutes exceeded
The burners have been unlocked 5 times in 15
minutes
Wait 15 minutes before
unlocking the burners
Flt08 Power supply circuit anomaly Failure at the circuit Replace the device
Flt09
Generic anomaly
Power was cut to the device when another type
of failure had occurred previously
Unlock the burners
Resonator anomaly Failure at the circuit Replace the device
Flt0A All burners locked
No gas
Restore the gas and unlock the
burners
Ionization electrodes dirty or not hit by the flame
Clean or reposition the
electrodes and unlock the
burners
The cook top is not grounded
Check the cables and unlock
the burners
Gas is leaking from one valve that caused the
unwanted lighting of a second burner while the
first was being lit.
This problem is caused by flame in the second
burner for more than 10 seconds.
Replace the defective valve
Flt0[
Communication errors in the
control logic
Failure at the circuit Replace the device
Flt0E
Error in the control of the
keypad
A mechanical deformation could have
compromised the support of the keypad by the
glass
Wait several seconds for the
keypad to recalibrate. If the
error persists, turn the power
off and on. If the error still
persists, replace the device.