Page 2
8
Q.
After
adding
a Clock battery, the cylinder must be
reprogrammed.
The Clock starts running after getting the time information from
the Programming device while programming the cylinder. The
Cylinder also reports having an RTC to the S10 software.
After
replacing
a Clock battery, reading its audit trails starts the
clock. Reprogramming is not needed.
7
O.
Install the front plate.
P.
Tighten the screw. Use tightening torque 0.35 …0.45 Nm.
6
M.
Turn authorized key ~15°.
N.
Turn the TORX 6 tool 90° counterclockwise.
5
J.
Slide the knob cover fully in its place.
K.
Insert the TORX 6 tool into the cover hole.
L.
Insert authorized key into the cylinder.
