18
EN
CHANNEL SELECTION
You can select the channel by using either
[CH
K
/
L
]
or
Channel number
buttons. How to select the
channel in each way is shown below.
1
Using
[CH
K
/
L
]
, or
Channel number
buttons
and pressing
[ENTER]
.
• Using
[CH
K
/
L
]
, change the channel.
• Same operation is available with
[CHANNEL
K
/
L
]
on the top panel of the main unit.
• When you select a channel, press the channel
number you want to view with
Channel number
buttons. The selected channel will be displayed.
- When selecting analog channel 12
- When selecting digital channel 12-1
Be sure to press
[–]
before entering the
minor-channel number.
• If the channel broadcasts NTSC and ATSC both
and you don't press
[–]
, then you will receive the
NTSC channel only. The moment you press
[–]
,
the lowest memorized digital channel will be dis-
played.
• When you press
[CH RETURN]
, the previously
selected channel will be selected.
About minor-channel broadcasting:
There may be different programs being broad-
cast on minor-channels through a single chan-
nel from ATSC. You can watch each minor-
channel program being broadcast by selecting
one of the minor-channels.
NOTE:
• In the DTV broadcasting, one channel sometimes broad-
casts multiple programs depending on the air time. In this
case, the main channel is called major channel and the
minor-channel is called minor channel.
ENTER
1
1
2
-
ENTER
1
2
ENTER
POWER
SLEEP
AUDIO
STILL
SETUP
BACK
SCREEN
MODE
INFO
CH RETURN
MUTE
VOL.
CH
1
2
3
4
5
6
7
8
9
-
0
INPUT
SELECT
ENTER
CH RETURN
1
2
3
4
5
6
7
8
9
-
0
CH
VOLUME ADJUSTMENT
This section describes how to adjust the volume
when viewing TV. The Mute function, which is use-
ful when you have a visitor or a phone call, will be
also described.
1
Using
[VOL.
X
/
Y
]
or
[MUTE].
[VOL.
X
/
Y
]
• You can adjust the audio volume with
[VOL.
X
/
Y
]
.
• The volume bar is displayed at the bottom of
the screen when adjusting the volume.
• Same operation is available with
[VOLUME
X
/
Y
]
on the top panel of the main unit.
• The volume bar display will automatically dis-
appear in a few seconds.
[MUTE]
• Press
[MUTE]
on the remote control to mute
the sound.
• To release the Mute status, press
[MUTE]
again or press
[VOL.
X
/
Y
]
.
• “Mute” is displayed on the screen for a few sec-
onds.
Mute
Volume
20
BACK
INFO
CH RETURN
MUTE
VOL.
CH
VOL.
MUTE
NOTE:
•
“No Signal” will appear on the screen after the minor-
channel broadcast is over.
You will need to change the channel to continue
watching another TV program.
: change automatically
: change manually by pressing
[CH
/
]
on your remote control
CH4-1
18:00
18:30
19:00
19:30
20:00
CH4-2
CH4-1
CH4-1
CH4-3
No signal No signal
CH4-3
ATSC
CH4
NTSC
No signal
CH4-2
CH4-1
No signal
W
ATCHING TV
