3
Fans are UL/CUL Listed, Standard 507.
1. Do not depend on any switch as the sole means of disconnecting power when installing or
servicing the fan.
2. Always disconnect, lock-out, and tag-out power source before installing or servicing.
Failure to disconnect power source can result in fire, shock, or serious injury.
3. Motor will restart without warning after thermal protector trips. Do not touch operating
motor; it may be hot enough to cause injury.
4. Do not place body parts or objects in fan or motor openings while motor is connected to
the power source.
5. All electrical connections should be made by a qualified electrician.
6. CAUTION - For General Ventilating Use Only. Do Not Use To Exhaust
Hazardous Or Explosive Materials And Vapors.
7. Follow all local and state/provincial electrical and safety codes in the United States and
Canada, as well as the National Electrical Code (NEC) and the Occupational Safety and
Health Act (OSHA) in the United States, and the Canadian Electric Code (CEC) in Canada.
8. Always disconnect power source before working on or near a motor or its connected load.
9. Protect the power cable from coming in contact with sharp objects.
10. Do not kink or create tight bends in the power cable and never allow the cable to come in
contact with oil, grease, hot surfaces, or chemicals.
11. Make certain that the power source conforms to the requirements of your specific exhaust
fan model. The fan frame and motor must be electrically grounded to a suitable electrical
ground, such as a grounded water pipe or ground wire system.
12. Do not operate any fan with a damaged cord or plug. Discard fan or return to an
authorized service facility for examination and/or repair.
13. Do not cover cord with throw rugs, runners, or similar coverings. Do not route cord under
furniture or appliances. Arrange cord away from traffic area and similar danger locations.
14. The discharge air is to be directed to the building exterior.
15. Questions? Please contact our service center by calling 1-650-952-2257.
Thermal Protection.
INSTALL IN INTERIOR WALL.
CAUTION -
MOUNT WITH THE LOWEST MOVING PARTS AT LEAST 2.5 m
(8.2 ft) ABOVE FLOOR OR GRADELEVEL.
CAUTION:
HOT SURFACE. AVOID CONTACT.
WARNING -
For indoor use only.
WARNING -
To reduce the risk of electric shock, do not expose to water or rain.
WARNING-
To Reduce The Risk Of Fire Or Electric Shock, Do Not Use This Fan
With Any Solid-State Speed Control Device.
Suitable for commercial or industrial use only.
IMPORTANT SAFETY INSTRUCTIONS
