OPERATING INSTRUCTIONS:
1.
Set fan on a dry, stable and flat surface.
2.
Connect the plug to any standard 120-volt AC outlet. Caution:
Make sure the Speed Control is in the OFF position.
3.
Change the setting on the speed control to the desired
operating speed --- OFF"0", LOW"1", MEDIUM"2" or HIGH"3".
4.
To change the tilt -angle of the Fan Head, loosen the Tilt
Adjustment Knob on the side of the Grille, tilt the Fan Head to
the desired angle and tighten the knob. The knobs on both
sides are tools for tilt adjustment.
Note
: It is normal for the motor to feel warm to the touch during
operation. The motor is thermally protected and will
automatically shut off when it overheats for any reason. If this
happens, immediately disconnect the fan from the power outlet.
The motor bearings are permanently lubricated at the factory
and do not require any additional lubrication.
REPLACING PLUG FUSE
When the fuse in the power cord blows, please replace the fuse
by following these steps:
1.
Disconnect the plug from the wall outlet. Do not unplug by
pulling on cord. Then slide open the fuse access cover on top
of attachment plug towards blades, as shown in Figure 1.
2.
Remove the fuse carefully using a flat head screwdriver, as
