99850-000782-03. E&OE.
Status LED
Green LED flashes – device OK
Data LED
Red LED flashes when messages sent on network.
Alarm LED
Red LED solid on for local initiated alarm
Red LED flashes for network initiated alarm
RS485 / DMX LED
Green LED flashes when DMX or RS485 messages are sent or
received
Device Identification
Press and release switch.
Sending a message to identify the device on the network
(red Data LED flashes).
Device LEDs and Buttons
Typical Connection Diagram
SCMR1232
12 x 32A Relay Controller
230V
N
L
DMX Start Address
1 - 512
To set non-sequential
channel addresses,
use iCANsoft and set
rotary encoders to start
address: 0-0-0
RS485 / DMX
termination
RS485 / DMX
Connection
Incoming Supply
Supply: 100-230V 50Hz 0.33A MAX
0.33A MAX
Auxilary Volt Free Contacts
2 x Volt free inputs
iLight Network
Termination
Connection
to the iLight
Network
DALI IN
Device
Identification
Switch
32A Max
Function
iCANnet Cable Colours
0V
Black
CAN L
Blue
Shield
Silver
CAN H
White
+VDC
Red
Maximum segment distance: 500m (1640 ft)
Devices per segment: 100 (without bridge or repeater)
Consult iLight for information on alternative cable types.
IMPORTANT NOTE: Connecting a mains potential cable to the
iCAN Network terminals is likley to damage the unit and other
devices connected, and invalidate warranty.
iCAN Network Connections
IMPORTANT NOTE:
Connecting a mains potential cable to the
iCAN Network terminals is likley to damage the unit and other
devices connected, and invalidate warranty.
