Note: If all above solutions don’t work, please take below actions.
1. Re-set the robot by re-turning on the power switch.
2. If re-set action doesn’t work, please contact [email protected]
Wheels or side brushes
disfunction
Check wheels or side
brushes
sensor failure
bumper slightly, check whether
there is foreign matter
Main body gets stuck
Move main body and start
again
Short tone
NO. Tone Cause Solution
01
02
03
Positioning the charging dock.
Wake up and charge your robot
Please the charging dock against a wall and connect the
adapter to an outlet. It is suggested to leave an area with
at least 4 feet (1 meter) on each side of the charging dock,
and at least 8 feet ( 2 meters) in front of the charging dock.
Do not place the charging dock around doors and stairs.
For optimizing performance of your robot, try best to place the charging dock in an
open and uncluttered area.
Always keep the power switch turned on during your
don't use your robot for more than one week.
Switch on the robot
Pause
A. Make sure the power switch is on.
B. Press CLEAN on the robot or on the remote control to start cleaning.
Pause the robot to switch from cleaning mode to select mode.
A. Press CLEAN button on the robot.
B. Press button on the remote control.
* To switch from sleep mode to select mode, press CLEAN. Press CLEAN again to
start cleaning.
Turn on the power switch at the side of body, then place
your robot on the charging dock for a full charge.
Before You Get Started See How V3s Pro Works
1.
2.
V3s Pro is ready to clean
Robot Maintenance
Trouble Shooting
1
2
Scheduling
Sleep
To turn robot into sleeping mode from selected mode:
Setting local time
A. Point the remote control towards the robot.
(Make sure the power switch is on.)
B. Press and then use directional buttons to set the correct time.
C. Press to save the setting.
A. Keep pressing CLEAN button on main body for 3 seconds.
B. Robot enters sleep mode if it does not receive any commands in 15 seconds.
3
Error code sheet
When the robot meets with some routine troubles ,it will remind you by beep.
Setting a schedule
A. Point the remote control towards the robot.
B. Press and then use directional buttons to set the scheduled.
C. Press to save the setting. To cancel the schedule, please set the time
after each use (High Performance Filter can’t be washed with water).
Replace with a new one when it is needed.