Operating manual - English
HALLEY BKA 2000
15
6.1.2 Setting the cutting spaces
ATTENTION: first carry out depth gauging then this gauging operation.
1) Insert the supplied gauges vertically in the clamps (side 1) (fig. 13, page 16).
2) move the clamp carriage until the tracer touches the gauge (fig.10).
3) turn the cutter manually.
4) the cutting interval is correct when the cutter skims the gauge in the right clamp (M). Otherwise
proceed as follows:
- loosen the screw (N1) of the tracer unit (fig.11).
- move the tracer unit next to the gauge in the left clamp (L).
- fasten the screw (N1).
- make sure the above mentioned condition occurs before the adjustment of the machine can be
considered correct.
Fig. 10
Fig. 11
6.1.3 Setting the cutting height
As for depth gauging. The cutter must skim the gauge
evenly, independently of the point of contact with the
tracer point.(in the centre, at the top, at the bottom). If
this is not so, loosen the screws (K) and adjust screw (J)
until ideal gauging is achieved (fig.12).
Fig. 12
L
M
N1
K
J