6
Picture 1
Figure 3
Figure 4
Pull the cable coming from external ventilation unit, and drive it 30cm into from the
hole located on the upper side of the hood.
Cut off the electrical connection of the hood. For such situations, turn off the fuse of
the hood.
* Place the hood on the section determined on the ceiling, and screw it to the ceiling as
shown in Figure 5.
Picture 2
Figure 5
Picture 3
7
Installation, taking off your product from its package:
*Check if there is any deformation on your product.
*Transportation damages and failures should immediately be reported to the
transportation responsible.
*
If you notice any damage please report to the seller.
*
Do not allow children to play with packing material!!!
Cable coming from external ventilation unit.
External ventilation units must be used for ceiling model hoods.
Before mounting of ceiling hoods, make the connections of previously selected
external ventilation system, and prepare the air outlet duct of 150 mm diameter and the
part which will be mounted to the ceiling, and fix the plastic chimney to flexi pipe by
using a clamp. After installing the hood on the ceiling, pull the plastic chimney and fix it
with wing nuts.
Air outlet can be provided from any side of the device. Unused air outlet hole should be
closed.
* For installing the hood to the ceiling, there should be a section on the ceiling that
corresponds to sizes given in technical drawing.
Drill an opening for the plastic chimney appropriate to the position of the air outlet.
Connection of External Ventilation Unit with the Hood:
*
Open the split-extraction sheet of the device and remove the filter (Figures 3 &
4).
Plastic chimney
Plastic chimney, assembled to air outlet of aspirator
(Picture 1)
In order to have the best performance avoid bends on aluminium flexible duct.
Correct
Incorrect
Standard Accessories
INSTALLATION THE HOOD
