IKH XW013, Instruction Manual, Page: 15 / 18

15
15. Use only original spare parts and accessories. The use of any other spare parts or accessories
than original parts may cause a risk of injury.
16. Reduce the risk of unintentional starting. Disconnect the machine always when not in use, be-
fore adjusting or servicing and when changing accessories such as drill bits etc. Make sure
switch is in off-position before plugging it in.
17. Many woodworking tools can kickback the workpiece toward the operator if not handled prop-
erly. Know what conditions create kickback and know how to avoid them.
18. Check the machine for damages. If you notice any damages in the machine, in its guards or
other parts, do not use it until it has been repaired in an authorized service center. Check for
alignment of moving parts, binding of moving parts, breakage of parts, mounting and any other
conditions that may affect the machine operation. Damaged parts should be properly repaired or
replaced by an authorized service center.
19. Never leave the machine running unattended. Turn power off and do not leave the machine until
it comes to a complete stop.
20. Do not use the machine when you are tired, sick or under the influence of alcohol, drugs, medi-
cation or similar that could affect your ability to use the machine safely.
21. Never allow unsupervised or untrained persons to operate the machine. Make sure any instruc-
tions you give in regards to machine operation are approved, correct, safe and clearly under-
stood.
22. If at any time you are experiencing difficulties performing the intended operation, stop using the
machine and ask an authorized service center how the operation should be performed.
SPECIFIC SAFETY INSTRUCTIONS
-
Read the instruction manual carefully before using the machine and pass it on to all other people
who use the machine.
- Make sure the machine stands stable on a firm level surface.
- Always be cautious when using the machine; there is a danger to your fingers, hands and eyes.
- All safety mechanisms and covers must be mounted and in place when using the machine.
Safety mechanisms may not be removed or rendered unusable.
- Operators must be at least 18 years of age.
- Persons working on the machine may not be diverted from their work.
- The working space must be free of wood chips and other debris.
- Do not wear gloves when operating the machine.
- Always wear safety goggles when working.
- Before cleaning, changing parts, rectifying malfunctions or performing any other procedures on
the machine, turn the switch off, unplug the machine and wait for the blade to stop completely.
- Only a qualified electrician is allowed to do electrical connections or repair work on the electri-
cal installation.
- All protection and safety devices must be replaced after completing repair and maintenance pro-
cedures.
- Place the stop as tightly as possible against the workpiece.
- Work only with well sharpened blades.
- When leaving the work place, switch off the motor and unplug the machine from power supply.
- Unplug the machine before moving it, even if only slightly.