10
Oil Extraction
1.
after vacuum, choose suitable probe (which is the largest diameter one can be
inserted into the engine) and tightly connect it to the extraction pipe connector.
(refer to Fig.2)
2.
Insert the end of the probe into the engine oil inlet hole of the engine.
3.
Turn on the ball valve (Fig.2)
4.
If waste oil only extracted into the
cylinder.
Please make sure the ball valve (Fig.1)
is closed.
5.
If waste oil extracted to the
oil tank
through the cylinder. Please open the ball
valve (Fig.1) accordingly. Also the oil tank need to be vacuum before extraction
operation.
6.
After finish extraction, turn off the ball valve (Fig.2) on the extraction pipe
Notice: Extraction of hot-oil, max. temperature for oil 60
℃
. Please do not
exceed 60
℃
. Please hold the black sleeve to avoid scald.
Ejection
Oil ejection from cylinder to underside oil tank
1.
turn off the air supply and Turn on the ball valve (Fig 1), if vacuum existed in the
tank, and then oil from cylinder will be fast transferred into the tank.
2.
If no vacuum existed in the tank, turn on the wing valve(fig 1) connected to the lift
pole to make a quicker transferring of waste oil into the tank.