2
Initial Camera Setup
-
Set camera mode switch to “Av” Aperture Priority.
-
Set White Balance to auto “AWB.”
-
Set Light Metering to “Center-Weighted Avg.”
-
Set ISO to 80.
-
Set Flash to forced ON (flash always fires) “Lightning Bolt.”
-
Set Review to “5 Seconds.”
-
Set AF-assist beam to “Off.”
-
Set Red-Eye Correction and Red-Eye Lamp to “Off.”
-
Set AF Frame to “Center” and Servo AF to “Off.”
-
Set AF-Point Zoom to “Off.”
-
If the "Shortcut/Print" button is
not
assigned, functions of the rear control
dial can be accessed through the housing by holding down the
"Shortcut/Print" button and using the left/right buttons of the rear control
cluster.
-
The camera does NOT operate with TTL “automated” flash when in the
“M” manual mode. “M” manual mode should NOT be used with the
AF35
strobe.
- You can assign different camera functions such as ISO, WB, Metering,
AEL, and AFL to the “Short Cut” button and then change those settings
using the arrow buttons. Refer to your camera owner’s manual for
additional information.
-
In Manual mode, the Control Ring will operate the aperture setting.
Press the Ring Function button and set to +/- / Tv to change shutter
speed; set to “STD” to adjust aperture.
- Camera functions can be assigned to the Control RIng by pressing the
Ring Function button. Additional functions include ISO, +/- Exp./Tv, MF
Manual Focus, WB white balance, and Step Zoom. Depress the Ring
function button until the desired function is highlighted in the camera
LCD screen. Once the function is highlighted, it can be adjusted using
the Control Ring.
