Ikelite 6870.40, Instruction Manual

Page: 5 / 28

Flash Connection for External Strobes
When using an external strobe connect the housings Hot Shoe
Connector, slide the connector into the hot shoe of the camera
from the back of the camera as shown. Slide the connector
forward until
it stops. This can
be done after
the
camera is
secured with
the
mounting
bolt.
Caution:
Do not remove the
External Strobe
Connector's
waterproof cap
unless an
external sync
cord
is going to be
plugged in.
Installing Camera in Housing
Before installing the camera, pull out on the controls in the front
section of the housing. This will allow the camera to slide in
easier. Once the camera is installed and the lid snaps have been
closed, return the controls to their operating position.
5