13
14
Attach Battery Pack to Compact Video Dual Tray
NOTE:
Battery Pack can be mounted in either direction with the Female Connectors facing forward
or backward (preferred) on a Compact Video Tray.
Battery Pack is not compatible with a Compact Video Single Tray. Both a Compact Video Single
and Dual Tray must be attached to the Compact Video Housing in order to attach a Battery
Pack - see Optional Accessories and Spare Parts -
Page 16
.
1. Turn the housing upside down so the Battery Pack attachment holes on the bottom of the tray
are facing up.
2. Remove Battery Pack from Battery Pack Pouch.
3. Insert the 1/4-20 x 5/8” screws into the Mounting Plate so the screw heads are flush with the
textured side of the Plate.
4. Insert Plate with Screws into the Battery Pouch. Screws will protrude through Pouch holes
opposite the Ikelite logo. Position the Pouch so that the flap is facing towards back of housing.
5. Slide a phillips screwdriver through the logo side pouch holes and tighten both screws into Tray
Attachment Holes.
6. Insert Battery Pack into Pouch so that the Female Connectors face toward the back of the
housing. Close flap over the Female Connectors.
Attachment Holes on bottom
of Compact Video Dual Tray
Mounting Plate
1/4-20 X 5/8”
Mounting Screw
Battery Pack
Pouch Flap
Battery Pack Pouch
Attach PRO-2800 with SA-100 Arm to Compact Video Dual Tray
Attach one
Cord End to
PRO-2800
Bulkhead
Battery Pack
Attach other Cord End
to Battery Pack
Remove Bolt
if unused
Attach PRO-2800 w/SA-100 Arm to Compact Video Dual Handles
1. Remove 3/8-16 X 1-3/4” stud in top of one handle using
3/16” allen wrench.
2. Install 3/8-16 X 1-1/2” stud in top of handle using 3/16”
allen wrench.
3. Remove handle spacer (if present), slide arm mount and
3/8” washer over handle stud, tighten Wingnut.
4. Attach one Cord End to the Battery Pack
and the other Cord End to the
PRO-2800. Either Cord End can
be connected to a component.
NOTE:
If a Handle Stud is not
being used, remove it and
store in a safe location.
Wingnut
3/8” Washer
Battery
Pack
SA-100
Ball Socket Arm
Arm Mount
Cord
End
Handle Stud
Remove Stud
if unused
Cord
End
Diagram L
#9530.1 Compact
Video Handle
Diagram K
1. When using the SA-100 ball-socket arm, slide arm mount and 3/8” washer over tray stud, tighten
Wingnut -
Diagram K
.
2. Attach one Cord End to the Battery Pack and the other Cord End to the PRO-2800. Either Cord
End can be connected to a component.
3. Battery Pack can be mounted in either direction with Battery Pack Female Connectors facing
forward or backward.
4. Remove opposite side Tray Bolt if unused and store in a safe location.
-
When using the Flex Arm, use the same attachment procedure
as the Compact Video Handle on
Page 15 - Diagram M
.
- The Arm is NOT intended for use as a carrying handle.
The #9530.1 Handle -
Diagram L
is recommended for use
with the PRO-2800 Lite on a Compact Video system.
Female Connector
with Wate rproof Cap
Female Connector with
Waterproof Cap removed
