4
This product has been water pressure tested at the factory and is depth
rated to 200 ft. (60m). Thoroughly inspect and immerse the empty
housing completely in water before installing a camera. If any fogging
occurs or droplets of water enter the housing, do not install a camera.
Clean the housing main o-ring and retest to make sure that it is
watertight. Refer to the Troubleshooting section, page 17.
Please read your camera manual thoroughly to have a full understanding
of each camera function.
If you are new to underwater photography, be sure to read the Photo
Tips section, page 16.
Preparation
Initial Camera Setup
(before placing camera in housing)
-
Insert and Format an SD memory card.
-
Set Date and Time.
-
Set Mode Dial to “A” Aperture Priority. Manually adjust aperture setting
to achieve the best exposure for your shooting conditions. The shutter
speed will be locked at 1/60th second. Set Mode Dial to “M” Manual
mode to manually adjust both aperture and shutter speed settings.
-
Set Aspect Ratio to “4:3.”
-
Set Picture Size to “14M” and Quality to “Fine.”
-
Set ISO Sensitivity to “100” and White Balance to “AWB.”
- Set AF Mode to “1-Area” and Face Recog. to “OFF.”
-
Set Metering Mode to “Center Weighted.”
-
Set i.Exposure and i.Resolution to “OFF.”
-
Set AF Assist Lamp and Red-Eye Removal to “OFF.”
-
Set Image Stabilizer to “ON” and Focus to “Center AF.”
-
Set Flash to “Forced Flash On and Macro Mode to AF Macro .”
NOTE:
If overexposure occurs, use “-” exposure compensation, back away
from your subject and zoom in, or switch to “M” Manual mode, and
adjust aperture and shutter speed settings. When using an AF35 strobe
or manual controller, turn the power down.