13
Installing the Flash Deflector
1. Only the diffuser or deflector should be installed at any given time.
If a diffuser is attached to the port, remove it by pulling it away from
the port. The flash deflector must be installed prior to inserting the
camera in the housing.
2. Line the velcro dots on the deflector with the velcro dots on the
inside of the housing’s front. When properly aligned, the holes in
the deflector will line up with the fiber optic ports on the housing.
3. Press the deflector firmly into place.
4. To remove the deflector, lift the bottom with your thumb or a dull
instrument and pull away from the housing.
About Fiber Optic Cords
Connecting a strobe via fiber optic cord requires the camera’s built-in
flash to fire for every photo. Rapid firing will be limited to the recycle
time of the camera’s built-in flash or the recycle time of the strobe,
whichever is slower.
The following fiber optic cords are compatible with this housing:
•
Ikelite Fiber Optic Cord # 4501
•
INON Optical D Cable “Non-wireless type” L-Connector
•
SEA&SEA Fiber Optic Cable (L-type) # 50107
Velcro
