Installing the Camera
1. Remove any lanyard attached to the camera.
2. Pull out on each housing control until it stops. This will get the controls
out of the way for installation of the camera.
3. Remove the back from the housing.
4. Set the housing front on a table and gently slide the camera into the
front mounting blocks, Diagram A.
5. While holding the camera in its seated position in the front mounting
blocks, rotate the housing front 90° so the port is resting against the
table top, Diagram B. CAUTION: Camera is NOT secure in the
housing until the housing back has been installed.
6. See “Closing the Housing”, page 8.
Opening the Housing
Lid Snaps have a
Lock
. To open housing, push Lid Snap Lock forward
and lift as shown. Keep pressure on the
Lid Snap so it does not fly open quickly.
Some lid snaps have a lot of spring tension once
they go over center, so keep a firm grip on the lid
snap. Lid Snaps may be opened one at a time.
Push Forward
Lid Snap
Lock
Lift
Diagram A
7
Diagram B
Mounting Block
