U
Ussiinngg FFllaasshh
The camera’s built-in flash can be used to illuminate subjects
underwater. See Diffuser description on the next page.
8
D
Deefflleeccttoorr IInnssttaallllaattiioonn
See Deflector description on the next page for
using external flash.
Housing shown with
Deflector installed.
Deflector
D
Diiffffuusseerr aanndd D
Deefflleeccttoorr ccoonntt..
A diffuser and deflector are included with the housing. The
diffuser is white transparent plastic. The deflector is also white
but is not transparent and has a decal on the front.
To install the diffuser or deflector spread the port clamp at the
spring end and slide over the lens port. The white plastic should
be placed in front of the camera flash. The port clamp should be
pushed back against the front of the housing.
D
Diiffffuusseerr
The diffuser should be installed when using the camera’s built in
flash. When shooting with the camera’s built-in flash at
approximately 2 feet (0.6 m) or less, the lens port on the
housing may block a portion of the light from the camera’s
built-in flash, creating a shadow in the lower left of the photo.
To eliminate the shadow zoom the
lens slightly.
(You can test this
above water to see if the lens has
to be zoomed)
D
Deefflleeccttoorr
The deflector should be installed
when using an external strobe
such as the DS51 or DS125
Substrobe and EV Controller. The
deflector will redirect the
camera’s flash to the EV
Controller which controls the
external strobes output.
9
Deflector/Diffuser
Port Clamp
Spring
Spread to Install
This edge against housing
10
11
U
Ussiinngg tthhee CCaam
meerraa’’ss BBuuiilltt--iinn FFllaasshh
The camera’s built-in flash can be used to illuminate subjects
underwater.
U
Ussiinngg O
Oppttiioonnaall EExxtteerrnnaall FFllaasshh
TTTTLL EExxppoossuurree M
Mooddee
Ikelite DS Substrobes are fully TTL functional and provide real
Olympus TTL control with this housing. For TTL exposure you
must use a DS Substrobe and the Ikelite #4103.51 sync cord or
#4103.52 dual sync cord for dual strobes. N
NO
OTTEE::
Refer to
camera manual for settings when using an external strobe.
M
Maannuuaall EExxppoossuurree M
Mooddee
This camera can be used in the manual mode with any Ikelite
Substrobe, DS51, 100A, DS125, or 200. A #4103.51 sync cord is
required to connect the Substrobe to the housing.
M
Maannuuaall EExxppoossuurree M
Mooddee 22
Use the Ikelite EV-Controller with a DS Substrobe for more
control over manual exposure. The EV Controller provides 10
manual power settings in 1/2 stop increments. For housings with
an external sync cord connection it is recommeded to connect the
EV-Controller to the housing with a #4103.51 sync cord.
O
Oppttiioonnaall SSttrroobbee PPaacckkaaggeess
((TTTTLL EExxppoossuurree M
Mooddee))
#3944.51 includes
DS51 Substrobe
Ikelite TTL Sync Cord
SA-100R Arm
#3944.75 includes
DS125 Substrobe
1.5 hr. Smart Charger
Ikelite TTL Sync Cord
SA-100R Arm
DS51
Substrobe
SA-100R
Arm
#4103.51
sync cord
O
Oppttiioonnaall AAcccceessssoorriieess ccoonntt..
D
DSS5511 SSuubbssttrroobbee
The Substrobe DS51 covers
the equivalent of a 28mm
lens. It is the ideal choice
when using only the camera
lens or the camera lens with a
macro accessory lens.
D
DSS112255 SSuubbssttrroobbee
The Substrobe DS125 covers
the equivalent of an 18mm
lens, 100 degrees (with
diffuser). It is the ideal choice
when using accessory wide
angle lenses greater than
28mm.
