Ikegami IPD-DM11, Instruction Manual

Page: 9 / 36

4
This machine is compatible with PoE (Power over Ethernet)
When using the PoE feed HUB, power is supplied from the PoE HUB and
there is no need for subsequent "Confi rmation of power-supply voltage"
and "Power cable connection".
Confi rmation of power-supply voltage
Before connecting the power source, please ensure the power-supply
voltage is DC10.5 - 15V.
After checking the power-supply voltage, please switch off and perform
the connection operation.
Power cable connection (for DC12V power supply)
Peel off about 7mm
−
＋
The diameter is
0.2-1.0SQ (AWG24-18)
Insert the cable and fasten the screw
by using a flat-head screw driver.
The connectable cable diameter is 0.2-1.0SQ (AWG24-18).
When connecting, please ensure you switch off.
Please peel off about 7mm of the coating at the tip of the cable. If the
stripped section is too short, it will not be properly insertable into the
terminal
block, which may affect the connection. Also if too long, this is dangerous
because it may short circuit the portion exposed from the terminal block.
Please be careful to check the polar characteristics.