E-2
3. Names of parts and their functions
3-1. Front panel
①
POWER LED (green)
Stays on while the power is on.
②
HDD LED (green)
Stays on while the hard disk drive is accessed.
③
REC LED (red)
Stays on while recording is going on.
④
ETHERNET LED (green)
Lights up when data has been received from a camera in question.
⑤
ERROR LED (yellow)
Lights up if the hard disk drive gets in trouble.
3-2. Front panel (open view)
①
Power button
Make sure the main power switch on the rear panel is at the “I” (ON) position. Press this
button, and the recorder gets started in 1 minute or so. When this button is pressed again, the
recorder does the end processing and turns off in 20 minutes or so.
* Just press on the power button to shut down the recorder in usual way. If the button
is held down longer than 4 seconds, the power is forced off without the end process-
ing. But this is for shutting down the unit in case of emergency. Never hold down the
button under normal conditions.
②
Reset button
Press this button to get the recorder restarted. It takes about 90 seconds to reboot the unit.
③
DVD-RAM drive
Insert an FAT32-formatted DVD-RAM disk, which is writable faster than 5 times, to back up
the alarm records.
Recommended DVD-RAM disk
Hitachi Maxell
DRM47C.1P (1 disk), DRM47C.1P5S (5 disks)
Mitsubishi Kagaku Media
DHM47GN1 (1 disk), DHM47GN5 (5 disks)
① ② ③ ④ ⑤
② ①
③
