IKEA NUMRERAD, Manual

Page: 16 / 56

16 ENGLISH
Problem Possible Cause Solution
The temperature in the appliance
is too low/too high.
The temperature is not set correctly. Set a higher/lower temperature.
The door is not closed correctly. Refer to “Closing the door”.
The wine bottles temperature is too
high.
Let the wine bottles temperature
decrease to room temperature
before storage.
Many wine bottles are inserted at the
same time.
Insert fewer wine bottles at the
same time.
The door has been opened often. Open the door only if necessary.
There is no cold air circulation in the
appliance.
Make sure that there is cold air
circulation in the appliance.
There is too much condensed
water on the rear wall of the
refrigerator.
Door was opened too frequently.
Open the door only when
necessary.
Door was not closed completely.
Make sure the door is closed
completely.
Water flows inside the
refrigerator.
The drain hole at the back of the
appliance is clogged.
Clean the drain hole with a piece
of wire.
Wine bottles prevent water from flowing
to the drain hole at the back of the
appliance.
Make sure that wine bottles do not
touch the rear plate.
Water flows on the floor.
The door is not closed well.
Refer to "Closing the door", or
refer to the troubleshooting item
below ("The door does not close
completely").
The appliance tilts forward.
Tilt the appliance slightly backward
(a quarter-inch lower in the back).
Refer to the separate Assembly
Instructions for appliance level
adjustment.
The drip pan cracks.
Contact Authorised Service Centre
listed at the end of this manual.
The defrost water drain is clogged.
Clean the drain hole with a piece
of wire.
The door does not close
completely.
The shelves are out of position.
Make sure the shelves are in
correct position. Refer to "Movable
shelves".
The door gaskets are dirty.
Clean the door gaskets. Refer to
"Care and cleaning".
The appliance is not level.
Make sure the appliances
is installed in level. Refer to
"Levelling feet", or the separate
Assembly Instructions.
If your appliance still is not working
properly after making the above checks,
contact the Authorised Service Centre. You
can find the list at the end of this manual.
Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to the
separate Assembly Instructions.
3. If necessary, replace the defective door
gaskets. Contact the After Sales Service.