8
Reverse Refrigerator Door
1.
Remove the door stop from the bottom of the refrigerator
door.
2.
Replace the door stop on the opposite side of the refrigerator
door, making sure that the hole in the door stop plate is
aligned perfectly with the hole for the bottom hinge pin.
3.
Fasten the door stop to the door.
4.
Remove door hinge hole plug from freezer door. Move to
opposite side.
5.
Set aside refrigerator door until bottom hinge is installed on
the opposite side of the refrigerator.
Replace Doors and Hinges
IMPORTANT:
Provide additional support for the doors while the
hinges are being moved. Do not depend on the door magnets to
hold the doors in place while you are working.
Reverse Top Hinge
1.
Place the plastic spacer beneath the hinge so that it will be
between the hinge and the cabinet, making sure the holes are
aligned.
2.
Fasten the top hinge to the op posite side of the cabinet,
inserting the screws only halfway, so you will be able to
replace and align the freezer door later.
Install Refrigerator Door
1.
Insert the bottom hinge pin into the bottom hinge and fasten
the hinge to the cabinet. Do not tighten completely.
2.
Place the washer on top of the bottom hinge pin.
3.
Place the refrigerator door onto the pin of the bottom hinge.
4.
Measure the distance from the bottom of the refrigerator door
to the floor. The distance should be approximately 1
⁴⁄₅
"
(4.6 cm).
NOTE:
If necessary, loosen the bottom hinge, without
removing the screws, adjust the door to the correct height and
fully tighten the screws.
Install Freezer Door
1.
Place washer on the upper hinge pin of the center hinge.
2.
Place the freezer door on the upper hinge pin of the center
hinge.
3.
Insert the Top Hinge pin into the drilled hole in the top of the
freezer door. Do not tighten the screws completely.
4.
Align the doors so that the bottom of the freezer door aligns
evenly with the top of the refrigerator door. Tighten all screws.
NOTE:
The distance between the doors should be
approximately
³⁄₄
" (19 mm).
Final Steps
1.
Plug into a grounded 3 prong outlet.
2.
Reset the controls. See “Using the Controls.”
3.
Return all removable door parts to doors and the food to the
refrigerator.
A. Door stop screw
B. Door stop
B
A
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
WARNING