IKEA HOGKLASSIG, Manual, Page: 24 / 32

Problem Possible cause Remedy
comes on.
There is no cookware on the
zone.
Put cookware on the zone.
The cookware is incorrect. Use the correct cookware.
Refer to "Cookware guid‐
ance".
The diameter of the bottom
of the cookware is too small
for the zone.
Use cookware with correct di‐
mensions.
Refer to "Cookware guid‐
ance".
There is no cookware on the
zone or the zone is not fully
covered.
Put cookware on the zone so
that it fully covers the cook‐
ing zone.
Multi-Flexi mode operates.
One or more sections of the
function mode which oper‐
ates are not covered by cook‐
ware.
Place the cookware on the
correct number of sections of
the function mode which op‐
erates or change the function
mode.
Refer to "Flexible induction
cooking area".
Pre-Set Cooking mode oper‐
ates. Two pots are placed on
the flexible induction cooking
area.
Use only one pot.
Refer to "Flexible induction
cooking area".
and a number come on.
There is an error in the hob. Disconnect the hob from the
electrical supply for some
time. Disconnect the fuse
from the electrical system of
the house. Connect it again.
If comes on again, speak
to an authorised installer.
comes on.
There is an error in the hob
because a pot boiled dry. Au‐
tomatic Switch Off and the
overheating protection for
the zones operate.
Switch off the hob. Remove
the hot cookware. After ap‐
proximately 30 seconds, acti‐
vate the zone again. If the
cookware was the problem,
the error message goes out.
Residual heat indicator can
stay on. Let the cookware be‐
come sufficiently cool. Check
if your cookware is compati‐
ble with the hob.
Refer to "Cookware guid‐
ance".
ENGLISH 24