IKEA CB DC195, Manual

Page: 27 / 36

ENGLISH 27
Problem Possible causes: Solutions:
The control panel is
switched off, the appliance
does not work.
There may be an
appliance power supply
problem.
Check that:
• there is not a power outage;
• the plug is properly inserted
in the socket and any bipolar
power switch is in the correct
position (this enables the power
supply to the appliance);
• the household electrical system
protection devices are efficient;
• the power cable is not broken.
The appliance could be in
On/Stand by mode.
Turn the appliance on by briefly
pressing the button
(see On/Stand-by function).
The inside light does not
work.
The light may need
replacing.
Malfunction of a technical
component.
Disconnect the appliance from
the power supply and contact
the Technical Assistance Service
if you need a replacement.
The inside light flashes. Door alarm active.
It is activated when the
refrigerator compartment
door remains open for a
prolonged period of time.
To stop the alarm, close the
refrigerator door.
On reopening the door, check
the light works.
The temperature inside the
compartments is not low
enough.
There could be various
causes (see “Solutions”).
Check that:
• the doors close properly;
• the appliance is not installed
near a heat source;
• the set temperature is
adequate;
• the circulation of air through
the vents at the bottom of the
appliance is not obstructed (see
installation section).
There is water on the
bottom of the refrigerator
compartment.
The defrost water drain is
blocked.
Clean the defrosting water drain
(see section “Cleaning and
Maintenance”
Excessive amount of
frost in the freezer
compartment.
The door to the freezer
compartment is not
closed properly.
Check that there is nothing
preventing the door from closing
properly.
• Defrost the freezer
compartment.
• Make sure the appliance has
been correctly installed.
What to do if...