IKEA 503.660.68, Manual, Page: 23 / 36

ENGLISH 23
appliance on a floor or support
strong enough to take its weight
and in a place suitable for its size
and use. Make sure the appliance
is not near a heat source and
that the four feet are stable and
resting on the floor, adjusting
them as required, and check that
the appliance is perfectly level
using a spirit level. Wait at least
two hours before switching the
appliance on, to ensure that the
refrigerant circuit is fully efficient.
WARNING: When positioning
the appliance, ensure the supply
cord is not trapped or damaged.
WARNING: To avoid a hazard
due to instability, positioning
or fixing of the appliance must
be done in accordance with
the manufacturer instructions.
It’s forbidden to place the
refrigerator in such way that the
metal hose of gas stove, metal
gas or water pipes, or electrical
wires are in contact with the
refrigerator back wall (condenser
coil).
To guarantee adequate
ventilation, leave a space on both
sides and above the appliance.
The distance between the rear
of the appliance and the wall
behind the appliance should
be 50 mm, to avoid access to
hot surfaces. A reduction of
this space will increase the
Energy consumption of product.
Please remove the power cord
from condenser hook during
installation before connecting
product to power supply.
ELECTRICAL WARNINGS
It must be possible to
disconnect the appliance from the
power supply by unplugging it if
plug is accessible, or by a multi-
pole switch installed upstream of
the socket in accordance with the
wiring rules and the appliance
must be earthed in conformity
with national electrical safety
standards.
Do not use extension leads,
multiple sockets or adapters.
The electrical components must
not be accessible to the user
after installation. Do not use the
appliance when you are wet or
barefoot. Do not operate this
appliance if it has a damaged
power cable or plug, if it is not
working properly, or if it has been
damaged or dropped.
If the supply cord is damaged,
it must be replaced with an
identical one by the manufacturer,
its service agent or similarly
qualified persons in order to
avoid a hazard - risk of electric
shock.
WARNING: Do not locate
multiple portable socket-outlets
or portable power supplies at the
rear of the appliance.